How to properly protect the lexia 3 sealing performance

Repair the car line, body hole, the hole at the lexia 3  wear harness seals should be fitted in place, because these seals not only acts as a seal, but also played the role of protective harness. If the seal has been damaged or harness in the ring in rotation or traverse, should replace the seals, and it firmly with the body bore hole assembly harness securely.
Original window glass curvature glass in the window glass is damaged, you want to change, at the same time you want to check that there is no damage to the glass run channel seal. Windows often reply less than its original shape after repair, when in addition to to ensure easy pulling or lifting the window glass, but also pay attention to the tightness of the rear window glass around with the windows closed.
In the repair of a sealing flange of the door should be noted that repair damaged sealing flange, accurate recovery of the original shape of the flange. Tightness check and repair the door to check is: put a piece of cardboard in the closed position, close the door, and then pull the paper to judge according to the size of the Rally of the seal is good. If you pull the sheets the force required is too large seal tight, which would affect the door normally closed, and will cause the seal member due to the deformation is too Omo faster mourning for-sealing properties; the force required to pull the sheets too small, poor sealing door windshield rain phenomenon, often appear. Door replacement, must pay attention to the new doors inside and outside board the flanging bite at Tu the hemming glue, and small craft hole left when stamping block the use of the base tape.
Change roof around the roof lamination  Launch X431 GX3 coated with a layer of conductive sealant coated hemming glue times in the water tank and the seams to be welded before, This will not only help the body seal prevents body flange welds at the stagnant water and produce early corrosion. In the window below the door panel assembly door to paste an entire sealed isolation film, if there is no the molded sealing barrier film, to replace the use of ordinary plastic paper, then seal across the film paste compaction, Finally interior panels production assembly.
Replace the entire body, except that each of these projects should be completed, should also be in the lap portion of the weld and solder coat of sealant layer thickness should be about 1mm, and the adhesive layer may not have virtual sticky , bubbles and other defects; hemming in the folds should be coated with special glue; surface and front wheel cover the entire floor surface should be coated 3mm-4mm elastomeric coating and anti-corrosion coating; surface on the floor before the legislature sound and heat insulation, damping film board within the surface you want to paste, and then covered with insulation felt block, finally carpeted or mounted on a decorative floor. These measures can not only greatly enhance the tightness of the vehicle and slow down the corrosion rate of the body, but also can greatly improve the ride comfort.The spring car  obd2  should pay attention to clean the car to ensure that health